NISSAN FORKLIFT E 41 CODE CODE

Next the voltages you should get back probing the ecm connectorĥ0 - tps1 signal idle = approx 0.6v 2000 rpm = approx 0.7vĦ9 - tps2 signal idle = 4.5v = approx 4.4v Make sure you unplug both connectors before this testĪlso check for shorts between these wires When the fully-closed position learning value wasĬheck continuity between theses pins on the tps and the ecm connectors A malfunction occurs in relation between throttle position Throttle position sensor signal circuit is open or shorted. Sensor power supply voltage has a malfunction.

NISSAN FORKLIFT E 41 CODE CODE

Do not disassemble electric throttle control actuator.Į23 is a code for a throttle position sensor fault: 0:00 / 5:19 Nissan Forklift E-43 Code The Real Gonzalo 6.48K subscribers Subscribe 6.3K views 1 year ago Thanks for your support, hope you enjoyed this video, make sure follow and thumbs up. 'Throttle Valve Closed Position Learning and Idle Air Volume Position Learning and Idle Air Volume Learning' if replacingĮlectric throttle control actuator. Perform 'Throttle Valve Closed Position Learning' if disconnectingĬonnector. When the truck is sitting and its cold check the radiator antifreeze as well as the coolant in the overflow tank.

Blow out the whole truck especially the radiator because it is easily clogged and can throw that code. Do not apply voltage to throttle position sensor terminal. Before you start replacing any parts or what not, its best to follow the following steps. If there are any water drops, completely wipe them When removing and installing throttle position sensor connector. Make sure that there is no moisture around connector Im thinkin you probably pressure washed it to deathĪlso you have to change it as an entire unit so just order 2 sets of new gaskets and swap itĪnd no matter what you do reclean the connections with the cleaner (NON-CONDUCTIVE ELECTRICAL PARTS CLEANER ONLY!!!! no brake cleaner lol) then blow them dry You might want to try cleaning connections 1st before the swap and see if maybe you have some oxidation on the contact tipsīut there is a warning about moisture on the plugs when takin apart the tps You might want to try swapping on from another unit (at this point youve tried everything else)Īnd before you connect a new 1 clean all the connections again with a HIGH GRADE non conductive electrical cleaner and blow them dry Id say if those connections i listed above where good then you might have blown the tps Prosh itd be an E24 if the accel wires were broken

Nissan forklift e 41 code